| |
Megol Langzeitfett KP2G-30
A special grease with synthetic base oil and EP-additives for roller- and plain bearings at highest
loads. Because of its reliable lubricating performance it is excellently suited for highly loaded bearings,
unfavorable operating conditions and to extend relubricating periods. Due to its extremely adherent
lubricating film its application is especially advantageous for machines and vehicles in the construction
industry, including cement-and gravel plants and quarries, as well as in agriculture. From experience
we know that especially in these areas overloading often occurs due to shock and jolt stresses, dusty
environment, or lack of maintenance. Here the excellent lubricating performance of this long-term
grease really proves itself. When applied on normally loaded bearings, the relubrication periods may
be significantly extended.
Thanks to its good pumping behavior, megol long term grease is KP2G-30 also very well suited for
use in automatic lubricating units.
Service range
from -30 °C to +110 °C.
Identification acc.to DIN 51502: KP2G-30
Characteristic data |
|
|
approx. values |
Appearance and properties |
|
|
yellow-green, very sticky supple, soft |
Saponification type |
|
|
Ca |
baseoil |
|
|
|
viscosity at 40 °C |
DIN 51562 |
mm2/s |
900 |
Drip point |
DIN ISO 2176 |
℃ |
145 |
Consistency class |
DIN 51818 |
|
2 |
Fulling penetration |
DIN ISO 2137 |
0.1mm |
275-295 |
Fulling stability |
DIN ISO 2137 |
|
|
Difference after 5.000 u. 60 DH |
|
0.1mm |
<10 |
Difference after 100.000 u. 60 DH |
|
0.1mm |
<25 |
Property against water |
DIN 51807 Teil 1 |
|
1-90 |
Ant-corrosion properties |
|
|
|
Emcor-method |
DIN 51802 |
Corr.-degr. |
0 |
Copper strip test |
DIN 51811 |
Corr.-degr. |
1-100 |
Watercontent |
DIN ISO 3733 |
g/100g |
﹤0. 2 |
il seperation after 7 days And + 40 °C |
DIN 51817 |
g/100g |
1.6 |
Ashes, oxide |
DIN EN 7 |
g/100g |
1.8 |
Oxidation fall after 100 h at + 99 °C |
DIN 51808 |
bar |
<0.5 |
|
|
